How to install a new Etray on the Raptor from Enertion Boards

This guide will show you how to replace the Etray (buy here) on your Raptor 2.1

Tools needed:

3mm Hex tool

Phillips screw driver

Flat head screw driver

Step 1) Remove the 8 screws on the the enclosure using the 3mm hex tool 

Step 2) Unplug all of the connections shown below 

Step 3) Unscrew the 3 Philips screws on the Etray to remove it from the enclosure 

Step 4) Unscrew the 4 screws on the back of the Etray to remove the Unity. 

Step 5) Install the Unity on the New Etray and secure the Unity with the 4 screws previously removed 

Step 6) Plug all of the connections in the same manner they were removed 

Step 7) Secure the lid back on after opening

Step 8) Follow this guide to re calibrate the Unity just in case any of the motor wires have  changed orientation