Tuesday, 18 February 2020 / Published in
Tools you will need: 5mm hex key2.5mm hex key2mm hex key Begin by loosening the clamp rings on the grips. Undo the screw in each one by one or two full turns using a 2.5mm hex key until the grip can freely spin on the handlebars.  Your grip should now be able to slide off of the
Tuesday, 18 February 2020 / Published in
Tools you will need: 4mm hex key Remove the four standing platform securing screws using a 4mm hex key. Two of these screws are located at the rear of the standing platform, while the other two screws are toward the front of the standing platform and accessible by lifting up the crescent-shaped cutouts in the
Tuesday, 18 February 2020 / Published in
Tools you will need: 21mm open-end wrench, or 8-10” adjustable crescent wrench4mm hex key3mm hex key If you are working on the rear wheel, avoid touching the brake rotor during the entire process. If you accidentally touch the brake rotor, it can be cleaned with isopropyl alcohol. Let all of the air out of the